Wednesday, January 23, 2013

Browse » home» » Canon mx366 reset waste tank full

Canon mx366 reset waste tank full

Canon mx366 reset waste tank full might you can try this solution Hold the resume key in, press power key and hold it in. Let go of the resume key and press it twice, then let go of both keys. Wait for the machine to settle. (it may say Idle when it settles). Using the arrow keys navigate the menu until you see the Clear menu. Press "set" or "OK" (whichever your machine has) and navigate until you see the absorber count. Use the set or OK key to clear the count.

Here are the instructions for the MX310 from the manual (I don't know if they will work on your model).

After entering service mode using instructions above:

"When the Power LED lights in green (and "Service Mode Idle" is displayed on the LCD), press the
Stop/Reset button the specified number of time(s) according to the function listed in the table below,
then press the ON/OFF button. (Each time the Stop/Reset button is pressed, the Alarm and Power LEDs
light alternately, Alarm in orange and Power in green, starting with Alarm LED.)"

"4 times Green (Power) Ink absorber counter
resetting
Set a sheet of A4 or Letter sized plain paper in
the rear tray and reset the ink absorber counter.
After the ink absorber counter is reset, the
counter value is printed automatically.
See "Ink absorber counter resetting" below"


Reset the ink absorber counter (to 0%) when the ink absorber is replaced, or after the logic board is
replaced.
1) In the service mode, press the Stop/Reset button 4 times to enter the ink absorber counter resetting
mode.
2) In the ink absorber counter resetting mode, press the Stop/Reset button the specified number of time(s)
according to the kind of ink absorber whose value should be reset to 0%.

Time(s) *1 Ink absorber
0 times Main ink absorber (0%)
1 time Platen ink absorber (0%)
2 times Both the main and platen ink absorbers (0%)
3 times or more Press the ON/OFF button to return to the ink amount resetting mode.

3) Press the ON/OFF button to specify the ink absorber whose value should be reset to 0%.
4) After the ink absorber counter is reset, the counter value is printed automatically.
("D=000.0 Ps=000.0" is printed at the top left of the paper.)

Another way I've heard about is, once the machine says Idle, open the top cover, remove both the ink cartridges, close the cartridge holder cover and turn the printer off.
Close the top cover and turn the printer on. After the printer settles, reinstall the cartridges.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.